tim@lakesys.lakesys.com (Timothy Winslow) (09/29/89)
I have a problem! I have a Hazeltine Executive 80 Model 20 terminal, and a Star Gemini 10X printer. I am trying to get these to interface, but with no luck. I am sure I need a special cable, but I haven't been able to figure out the right combination! I will post the pinouts, and I am sure that someone reading this can E-Mail me the correct cable wire-up! Star Gemini 10X Hazeltine --------------- --------- 1 Chassis Ground 1 Chassis Ground 2 RD 2 TX 3 TX 3 RD 4 CTS 4 CTS 5 RTS 5 RTS 6 Not used 6 Always High 7 Signal Ground 7 Signal Ground 8 DCR 8 Always High 11 RCH 9-25 Not used 13 Signal Ground 20 DTR Here it is, plain and simple. Both of these are set at 2400 baud, and both work, as I can get a modem to work on the regular port on the Hazeltine, and the printer runs nicely on an IBM! Please help me!!!!!! ======================================================================== | | | Timothy Winslow aka: P00h Bear, Winny, and other assorted names | | | | My outlook on life: Have fun, in whatever you do! | | | | tim@lakesys.lakesys.com or uunet!marque!lakesys!tim | | or csd4.cds.uwm.edu!lakesys.lakesys.com!tim | ========================================================================