jayen@cs.mu.OZ.AU (Jayen Vaghani) (01/15/91)
We recently got Foxplus 2.0 but had problems getting our application
going. In particular, we had two major problems:
1. When calling another procedure file which contains a
a 'set procedure to ..' statement, the system forgets
where to return to when the procedure file executes a
'return'. This has worked fine with the previous versions
of Foxplus that we have used.
The procedure file needs to contain the 'set procedure to'
statement since there are other procedures in the file
that need to be called later.
2. The other problem is writing control characters to the
terminal. Apparently, in Foxplus 2.0, such characters
cannot be written anymore with the "?" command. We are
working dedicated hardware so we were using control
characters to achieve some required effects.
If anybody can shed some light on these problems, it would be
most appreciated.
Thanks, Jayen.
--
-------
UUCP: {uunet,ukc,ubc-cs,mcvax}!munnari.oz!jayen
ARPA: jayen%munnari.oz@uunet.uu.net