pcb@gator.cacs.usl.edu (Peter C. Bahrs) (08/02/90)
I have received a lot a feedback from the net. THANKS.
I have an Ungermann Bass (32 of them) NICPS2 boards. I am trying
to get the clarkson drivers to work with them.
So I ran the new driver ubnic.com. The parameters needed for
this are sft_int_addr interuupt_number and memory address. I did
not see this driver listed in drivers.doc?
So I used 0x62 and 0x7E as the first parameter and 3 as the second.
What is the third parameter? The io address or Ram address?
eg. ubnic -n 0x7E 3 0xD0000 worked on one machine and
ubnic -n 0x7E 3 0x1550 worked on another but I could not
swap settings on either machine! hmmm....
Anyway, It seemed to load. I could run several of the p*.com utility
files and access it.
Now, I then ran ipx and net3 for netware access and it ran fine. However,
I think this was a goof. I did not econfig the client ipx as it
says not a configurable driver (both client ipx and server net$os.exe say
this). So I don't know if ipx bypassed ubnic, if that is possible.
I can login to the server...
Now I got some kaq9 (spelling?) software and tried to configure it with
ubnic. Someone who is familiar with the setup for a 3com board helped.
Everything set up okay but the invocation of ftp or telnet froze
the machine. Hence, the close but not cigar.
Is there a better suite of tcpip software I should try? Such as the
ncsa stuff.
Any ideas?
/*----------- Thanks in advance... --------------------------------------+
| Peter C. Bahrs |
| The USL-NASA Project |
| Center For Advanced Computer Studies INET: pcb@gator.cacs.usl.edu |
| 2 Rex Street |
| University of Southwestern Louisiana ...!uunet!dalsqnt!gator!pcb |
| Lafayette, LA 70504 |
+-----------------------------------------------------------------------*/