cjs@oberlin.UUCP (chris seline) (11/09/87)
I can not get my Diablo 630 RO to print with my A1000. I'm afraid I don't
know much about hardware. I have a cable with pins 1-8, 10-13, and 17-25.
The pins don't switch around. i.e. pin 1 at one end goes to pin 1 on the other
end. How do I rewire this cable so I can print? Using this cable I can not
even get garbage from the printer.
Diablo RS-232-C
PIN NOTES
1 Protective Ground
2 Transmitted Data
3 Received Data
4 Request to send (Always high when power is on)
5 Clear to Send
6 Data Set Ready (Must be Hi to receive data)
7 Signal Ground
8 Rcvd Line Sig Detect
11 (Printer Ready)
20 Data Terminal Ready
Amiga 1000 RS-232-C (From Amiga Hardware Manual, Apendix E)
PIN DIR STD NOTES
1 Y Frame Ground -- do not tie to logic ground
2 O Y Transmit data
3 I Y Receive data
4 O Y Request to Send
5 I Y Clear to send
6 I Y Data set ready
7 Y Signal Ground -- do not tie to frame ground
8 I Y Carrier Detect
9 n ---
10 n ---
11 y ---
12 n ---
13 n ---
14 n WARNING -5V
15 O n Audio Output
16 I n Audio Input
17 O n 716 kHz clock
18 I n Asserting this OPEN COLLECTOR...will generate level 2 interupt
19 n ---
20 O y Data terminal ready
21 n WARNING +5V
22 n ---
23 n WARNING +12V
24 O n 3.58 MHz colorburst clock
25 O n Amiga system reset
^
|-----refers to whether it is standard or not
Thanks in Advance
Chris Seline
cjs@oberlin.edu (internet)
scs7317%ocvaxa@vb.cc.cmu.edu (bitnet)
ihnp4!oberlin!cjs (uucp)