billb@stech.UUCP (Bill Burton) (08/26/89)
We originally had to systems, amcad and stech. Amcad has been disconnected
so I would like to set up stech to receive mail sent to amcad.
Is there some way I can set up uucp on our 3B2/400 with 3.0 to facilitate
this? Or, is it better to solve this with a modification to our map entry?
I should note that stech and amcad do not necessarily have to talk to the
same systems.
While I'm at it, is there anything particular I should know about setting
up our 3B2 with smail 2.5?
Please respond by e-mail since I may not be able to read any of the replies
before they expire :-) .
Thanks in advance,
Bill
--
William D. Burton, Jr. @ American Academy of Arts and Sciences
Cambridge, Mass. Voice: +1-617-576-5023
UUCP: ...!{husc6|allegra}!stech!billb
Internet: billb%stech.uucp@husc6.harvard.eduelliot@alfred.UUCP (Elliot Dierksen) (08/27/89)
In article <1139@stech.UUCP>, billb@stech.UUCP (Bill Burton) writes: > We originally had to systems, amcad and stech. Amcad has been disconnected > so I would like to set up stech to receive mail sent to amcad. Bill, You can change the system name you use if you have HoneyDanBer uucp. Or at least that's the only one I know how to do it on. In either the LOGNAME or MACHINE entry, you use MYNAME=fakesys. Hope that helps!! I am sending you mail also, but I thought this might be worth a post. EBD -- Elliot Dierksen UUCP: {peora,ucf-cs,uunet}tarpit!alfred!elliot "You can only be you once, but you can be immature forever!"