omsi@reed.UUCP (OMSI) (11/12/86)
I've recently undertaken the task of trying to bring up the seismo version of 2.9 (converting over from the original distribution). I get the system to come up, but when in multi-user mode, after a short while, I begin to get "out of swap" errors left and right. I've applied patches 1-16, and a few unnumbered ones, but none seem to relate to this problem. I vaguely recall some discussion about this a while back, but don't recall if anything was resolved. As a side note, I have a set of RL02 emulating drives (IOMEGA bernoulli box with TD systems controller). When the system tried to auto-configure these, it hangs. Removing the dtab entry allows me to boot and use them. Anyone else have this problem? Many thanks, Bob Ankeney tektronix!reed!omsi