[net.periphs] Help with Tektronix DAS 9100 Logic Analyser

rick@cheviot.UUCP (Rick E.R.G. Brooker) (01/10/85)

<211@cheviot.UUCP> cancelled from rn.

rick@cheviot.UUCP (Rick E.R.G. Brooker) (01/10/85)

I have a Tek' DAS 9100 Logic Analyser connected to a PERQ over an IEEE 488
(GPIB) bus. Using the 'binary save and restore' commands I can up-load
the analyser's set-up into the PERQ but I am unable to down-load it back
again.

The manual pages for this piece of equipment are not clear about
whether the checksum of the saved data should be returned when it is restored.
Either way I can't get it to work. The only response from the analyser is
the (undocumented) Error Code 402.

I would be grateful if anybody with experience of using a DAS 9100 on
a GPIB could mail me some advice, information etc.

Many thanks.

Rick Brooker.

ARPA :  rick_brooker%kelpie%cheviot%newcastle.mailnet@mit-multics.arpa
JANET : rick%kelpie@neda