tywang@nucsrl.UUCP (Tswei-Ying Wang) (07/31/87)
I have an Ultrix 1.2 system on a MicroVAXII being used as a communications
gateway between a small campus ethernet and ARPANET. I am also attempting
to gateway to another inter-university ethernet network, so I have
installed a second DEQNA in the MicroVAX. I rebuilt the kernel with two
qe's defined and fired up the new system. I was able to use the ethernet
for communications on the university but noticed some very strange
problems with the kernel. I discovered that the commands "ps ax" and
"netstat -i" would print out the header on the standard output device, but
the rest of the output was not appearing. I thought there may be a
problem with the new DEQNA and shut the system down to single user mode
and rebooted the system. I booted the system in single user mode and I
entered the "ps ax" command at the console and once again noticed that the
header was printed at the console but no line print outs about swapper and
the other immediate processes.
I decided to call customer service and run some hardware tests. I swapped
DEQNA's and ran ethernet communications on a system with one DEQNA
configured in the kernel. Everything ran just fine! I booted up the kernel
with two DEQNA's and once again experienced the problems discussed above.
I decided to run a little trick and define both IP addresses to have the
same network number and attempt communications. I was able to telnet to
either IP address and run basic communications. Unfortunately, some standard
output lines were not arriving at the standard output device as was
experienced at the console, dhu terminals, or ethernet/telnet logons.
I do not have the slightest clue as to what the problem may be. If this
is well know information and does not deserve reply posting, please mail
information to:
woodward@eecs.nwu.edu
or ernie@accuvax.nwu.edu
or ernie@nuacc.bitnet
Thanks for all the help in the past and I will greatly appreciate any
advice anyone has to offer.
Sincerely,
Ernie Woodward
----------------------------------------------------------------------
woodward@eecs.nwu.edu
ernie@accuvax.nwu.edu
ernie@nuacc.bitnet
Manager of Computer Communications and Networking
Academic Computing and Network Services
Northwestern University
2129 Sheridan Road
Evanston, Illinois 60208
(312) 491-4078avolio@decuac.dec.com (Frederick M. Avolio) (08/02/87)
In article <3680023@nucsrl.UUCP>, woodward@nucsrl.UUCP (Ernest Woodward) writes: > > I have an Ultrix 1.2 system on a MicroVAXII being used as a communications > gateway between a small campus ethernet and ARPANET. I am also attempting > to gateway to another inter-university ethernet network, so I have > installed a second DEQNA in the MicroVAX. I rebuilt the kernel with two > qe's defined and fired up the new system. I was able to use the ethernet > for communications on the university but noticed some very strange > problems with the kernel. I discovered that the commands "ps ax" and > "netstat -i" would print out the header on the standard output device, but > the rest of the output was not appearing. I thought there may be a > problem with the new DEQNA... I know of no problems with a 2 deqna configuration. In fact, we had such a setup ere in our office and I do not recall having to do anything special. The problems you report with ps and netstat sound like you were running a kernel whose name was something other than "/vmunix" but neglected to tell them that... Fred.