michaele@vice.ICO.TEK.COM (Michael Enkelis) (08/26/89)
Help! I am trying to get a versatec device driver built for 4.3. All goes well in the compile/link steps, but during bootup in the autoconfigure i get the following message when trying to configure the vp. machine check 8: unalgn ioref params ffff3e,0 pc 80030f65 psl 4 mcesr 0 panic: mchk dumping to dev b01, offset 0 dump succeeded The board i have is a Versatec controller model 121, factory strapping. If i configure my system for a lp, everything autoconfigures fine, which makes me think that the board is ok since i tried two other boards with the same results. This is my config file. # # VAX 730 # machine vax cpu "VAX730" ident ENKY timezone 8 dst maxusers 8 options INET options NS options QUOTA config vmunix root on rb0 controller uba0 at nexus ? controller idc0 at uba0 csr 0175606 vector idcintr disk rb0 at idc0 drive 0 disk rb1 at idc0 drive 1 disk rb2 at idc0 drive 2 controller sc0 at uba? csr 0176700 vector upintr disk up0 at sc0 drive 0 disk up1 at sc0 drive 1 controller zs0 at uba? csr 0172520 vector tsintr device ts0 at zs0 drive 0 device dmf0 at uba? csr 0160340 flags 0xfc vector dmfsrint dmfsxint dmfdaint dmfdbint dmfrint dmfxint dmflint #Select ONE, but not BOTH. device vp0 at uba? csr 0177500 vector vpintr #device lp0 at uba? csr 0177514 vector lpintr pseudo-device sl pseudo-device pty pseudo-device loop pseudo-device ether # The version of /sys/vaxuba/vp.c is "vp.c 7.1 (Berkeley) 6/5/86" Michael Enkelis michaele@enky.UUCP -- _ _ _ __ ' ) ) ) / /) / ` / /) Michael Enkelis / / / o _. /_ __. _ // /-- __ /_ _ // o _ tektronix!vice!michaele / ' (_(_(__/ /_(_(_(<_(/_ (___, /) )_/ <_(<_(/_(_/_)_ (503) 627-4099