williams@cs.dal.ca (Trevor Williams) (07/29/89)
Hello,
Ok, I've just gotten my ATI VGA WONDER card, but my monitor is on back
order for about a month. Meanwhile I'd like to use my Multisync grey scale
monitor. The catch is that right now my monitor is set for TTL signals, which
is find so long as I don't want to use any of the VGA modes. There is a
switch on the monitor to switch to analog input. The rub is that the VGA
Wonder sends its analog signal down a 15 pin connector, and all I have hooked
up to the monitor is a nine pin input. There is no connector for a 15 pin
input. Thus I assume that some sort of a conversion cable is required.
Can anyone point out the pin outs for such a converter?
Thanks,
Paul
Paul A. Lalonde UUCP: ...{uunet|watmath}!dalcs!dalcsug!lalonde
Phone: (902)423-4748 BITNET: 05LALOND@AC.DAL.CA
"The only true law is that which leads to freedom"
- Richard Bach, _Jonathan Livingston Seagull_
--
Paul A. Lalonde UUCP: ...{uunet|watmath}!dalcs!dalcsug!lalonde
Phone: (902)423-4748 BITNET: 05LALOND@AC.DAL.CA
"The only true law is that which leads to freedom"