ralex@ncrclm.Clemson.NCR.COM (alex) (08/03/89)
I'm having problems getting uucp up and running through a micom terminal switch. I have an NCR Tower 32/600 with UNIX Sys V 2.01. I am using HoneyDanBer. My files are set up as follows: Systems: systemname Any switch 9600 uusysname "" \r\d\r\d ogin: uuother word: test Devices: switch tty09 - 9600 micom Dialers: micom "" "" \s\c NAME \D\r\c CONNECT I also have Permissions set up, but it is not relavent to this discussion. I run 'Uutry systemname' with the following results: mchFind called (systemname) conn(systemname) Device Type switch wanted mlock tty07 succeeded generic open failed, errno = 9 getto ret -1 Call Failed: CAN'T ACCESS DEVICE exit code 101 Conversation Complete: Status FAILED Comments: 1) I know that the port is good 2) I know that the cable is good 3) I am less sure of whether or not micom is set up correctly If you can help in any way I would appreciate it. Please send your responses to me and I will summarize. Thanks for your help. Becky Alexander ralex@ncrclm.UUCP