smarc@mas.UUCP (Marc Siegel) (01/26/91)
In article <7186@ozdaltx.UUCP>, ian@ozdaltx.UUCP ( Philadelphia) writes: > > > Hello net-landers, > Help!!! > > I have just purchased SCO UNIX SYS V/386 rel 3.2.2. I > have an Intel 386 16 megahertz before I purchased this > product I called SCO to find out if my equipment was > compatible I have a Princeton Graphics Systems HX-12 CGA > monitor. The video card is made by Tandon. I have also Isn't the HX-12 an EGA monitor? Maybe that's an HX-12E? I have a Princeton HX-12E, and it is an EGA monitor. When using this with ATI EGA Wonder, I had to turn switch 8 off on the display card or I had the same problems. Switch 8 controls some extended functions of the card. > tried to use an ATI graphics solutions card (CGA) as > well. My problem is that when I go to install SCO I start > with the boot disk it loads the data then prompts me for > the files system disk when I put this in and hit enter > about 2 seconds later the screen goes funny. It looks > almost like an vertical hold problem. If I adjust the v- > hold on the monitor I can make out some of what is being > written to the monitor. If I take the selections and > [rest deleted] I used a cga monitor at one time with a Tandon Dual-Mode Video card which gave me many problems. This card interferred with serial communications and caused other grief as well. > Thanks in advance. > Scott Scheingold > > Voice Phone 215-732-7685 > > Where I post and read from I am known as ian. Hope this helps. _ ' )--,--, | Marc Siegel / / / __. __ _ | Emtronix Data Services / / (_(_/|_/ (_(_' | Randallstown, Maryland | {uunet}!wb3ffv!mas!smarc I know, it's only rock-n-roll, | smarc@mas.wb3ffv.AMPR.ORG but I like it.