[comp.sys.misc] Micropolis 1325T help needed

mann@eskimo.celestial.com (8718) (05/13/91)

I have a micropolis 1325T (ST-506 interface) which I am trying
to get running on a Tandy 6000. I keep getting a "Drive Not Ready"
diagnostic when I try to format it. I doubt I have a controller
problem (but possible) and my suspicion is that a component on
the drive board has failed. I need either a schematic (or source
of) the board that is on the drive or (less desirable) the
pin ID of the "Drive Ready" signal.

Any help much appreciated!

Thanks from Tom "The Old" Mann.