rhaar@rcsuna.UUCP (Bob Haar CS50) (07/29/89)
The following S-100 bus CP/M stuff is for sale. Prices include shipping except where marke " + S/H " hardware: Compupro S-100 rack-mount cabinet (the original "boat-anchor") $50 + S/H with "big-mutha" power supply, CV transformer, etc. 2 Siemans FDD100-8 8" SSDD floppy drives in rack-mount cabinet $75 + S/H (one of the drive is tempermental - doesn't work with some diskettes - maybe alignment problem??) Tarbell CPU I/O board, model 3033 $35 Z80, 2 serial ports, memory management, etc. 2 Seattle Computer 64K static RAM boards $30 each Tarbell Double Density floppy disk controller $30 SD Systems VDB8024 video display board $25 BMC green phosphor monitor $30 Keytronics VT100-layout keyboard $25 serial TTL interface Software: ZCPR3 (Z3PLUS auto-install version) plus ZCPR3 sources $30 and manuals WORDSTAR CP/M release 4.0 $25 I will sell the whole thing for $150 plus shipping and throw in about 80 8" floppies with lots of miscellaneous public domain software. All offered on an AS-IS basis. It was working the last time I tried it. Robert Haar phone: (313) 986-1412 (work) 651-4183 (home) UUCP: edsews!rphroy!rcsuna!rhaar CSNET: HAAR@GMR.COM
cmcmanis@stpeter.Eng.Sun.COM (Chuck McManis) (11/08/90)
Well, I've got quite a bit of stuff, the most interesting is a Cromemco
System III 22 slot mainboard with dual PerSci 8" voice coil drives. My
own BIOS (source included) and of course a bunch of applications. I
switched most of my computing requirements over to an Ampro little
board and don't power up Goliath much any more. The System III case is
rack mountable (that's where I have it now) with a slide in card cage.
I've got several 64K memory boards, a couple of CPU-Z's (one spare) a
16FDC controller, some analog I/O channels, a bunch of serial ports,
the Xebec SASI hard disk interface (I never did build a driver for it)
and assorted parallel I/O ports. (plus a dedicated printer port board).
All this stuff works, it has ZCPR3 installed. The BIOS code supports 8"
and 5.25" drives simultaneously on the 16FDC. I'll even include the
rights to redistribute the BIOS source if you'd like. Anyway this is
most of what you need to run Cromix if that were of interest. I've
also got CDOS for it, (but no CDOS apps)
Call me (408) 749-8815 if you are interested. Any reasonable
offer accepted. F.O.B. Sunnyvale CA. (This thing must weigh
about 50 lbs fully loaded.)
--
--Chuck McManis Sun Microsystems
uucp: {anywhere}!sun!cmcmanis BIX: <none> Internet: cmcmanis@Eng.Sun.COM
These opinions are my own and no one elses, but you knew that didn't you.
"I tell you this parrot is bleeding deceased!"