John_A_Pham@cup.portal.com (01/16/91)
Does anyone know anything about this board (Compupro Disk 2 cntrl)? I believe it is a hard disk controller to SA-4000 <?>. Is SA-4000 compatible with ST-506? John
mwilson@crash.cts.com (Marc Wilson) (01/16/91)
In article <38075@cup.portal.com> John_A_Pham@cup.portal.com writes: >Does anyone know anything about this board (Compupro Disk 2 cntrl)? >I believe it is a hard disk controller to SA-4000 <?>. Is SA-4000 compatible >with ST-506? The Disk 2 is a two board set. If you don't have both boards, you can't use it. CompuPro's Disk 2 is a SA-1000 ( ie. 8" ) HD interface. Specs basically read like those for the Disk 3, except for the interface (DMA across 64k boundaries, intelligent controller, etc. ) It's no longer supported, but CompuPro will still answer questions about it. The manual is still available from them, too. Give tech. support a call. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Marc Wilson ARPA: ...!crash!mwilson@nosc.mil ...!crash!pnet01!pro-sol!mwilson@nosc.mil UUCP: [ cbosgd | hp-sdd!hplabs | sdcsvax | nosc ]!crash!mwilson INET: mwilson@crash.CTS.COM ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ -- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Marc Wilson ARPA: ...!crash!mwilson@nosc.mil ...!crash!pnet01!pro-sol!mwilson@nosc.mil UUCP: [ cbosgd | hp-sdd!hplabs | sdcsvax | nosc ]!crash!mwilson INET: mwilson@crash.CTS.COM ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~