paul@devon.UUCP (09/30/87)
There's been some discussion lately about having a getty for Tandy Xenix 3.x that allows one to set up an inbound modem to switch between 300, 1200 and 2400 baud. Someone (michael@stb?) said that they had written a getty and would post it. So what's the problem? All versions of Tandy Xenix since 3.1.0 have been able to do just that! In an addendum that came with the 3.1 upgrade package (_Using_the_Dial_Program_), the following `speed' codes for use in /etc/ttys were defined: Code Baud Rate cycle 3 1200 -> 300 5 300 -> 1200 P 300 -> 1200 -> 2400 Q 1200 -> 2400 -> 300 R 2400 -> 300 -> 1200 - paul -- Paul Sutcliffe, Jr. UUCP (smart): paul@devon.UUCP UUCP (dumb): ...{rutgers,ihnp4,cbosgd}!bpa!vu-vlsi!devon!paul
cc1@ucla-cs.UUCP (10/02/87)
In article <472@devon.UUCP> paul@devon.UUCP (Paul Sutcliffe Jr.) writes: [Discussion about the discussion about the speed of getty and 2400] >300, 1200 and 2400 baud. Someone (michael@stb?) said that they had >written a getty and would post it. yes I had, and my drive is still in the shop... :So what's the problem? All versions of Tandy Xenix since 3.1.0 have :been able to do just that! In an addendum that came with the 3.1 :upgrade package (_Using_the_Dial_Program_), the following `speed' codes :for use in /etc/ttys were defined: : : Code Baud Rate cycle : : P 300 -> 1200 -> 2400 : Q 1200 -> 2400 -> 300 : R 2400 -> 300 -> 1200 What addendum? What is this? I had to re-write (ok, modify) dial to get it to work properly. I had to re-write a getty because none of the numbered switches documented in the manual (obvious place to look, right?:-) would work. <sigh>. Where can I get this beast? Sounds like it can be useful. Michael p.s. Why not 2400 -> 1200 -> 300? The opinions represented here are a result of being educated at a school that discriminates againts roosters. Only the birds are responsible.