dunlap@apl-em.UUCP (John Dunlap) (06/24/89)
I have purchased the Wollongong TCP/IP for the HP-9000 series 500.
I wonder if anyone has the same difficulty I have.
The command:
remsh remote_host cat < local_in > local_out
does not run correctly on my model 550 running HP-UX 5.21.
Most of the time it hangs when then file "local_in" is
about 7 Kbytes leaving the "local_out" file at 5120 bytes.
Sometimes it completes correctly.
The same behaviour is noted when "remote_host" is replaced with "me".
The same command (rsh on BSD 4.3) runs fine with the Wollongong/HP
rshd (daemon).
I have tried it with and without the 5.15 segment 10 update and
obtained the same results. Wollongong has exactly the same
system with a model 540 and we cannot figure out what is different.
The command without the output redirection works fine to the screen.
remsh remote_host cat < local_in
John Dunlap
hpfcse!hpubvwa!apl-em!dunlap
dunlap@apl-em.apl.washington.edu
Applied Physics Laboratory
University of Washington
1013 NE 40th St
Seattle, WA 98105