mbfriedman@amherst.bitnet (05/17/91)
We need some information regarding talking to an HP ScanJet through the parallel port on the back of a Series 400 Computer running HP-UX 7.03. We have the new parallel kernel driver, and can talk to parallel printers fine, but we don't seem to be able to talk to the ScanJet at all. The documentation we got in the shar does not cover talking to ScanJet's. Any help would be appreciated We do have the Developers Guide and which escape codes to use are *NOT* the problem! thanks, Mike Friedman
ken@hp-ptp.HP.COM (Ken McMullen) (05/21/91)
Hi, I setup an HP Scanjet Plus with the following information. Hope it helps. cable: hp92284A or 25 pin male parallel to 36 pin male centronics dfile: add "parallel" mknod /dev/scanio c 21 0x0c0000 Ken McMullen ..............................Sunnyvale Workstation Marketing (408) 746-5348 ....................................Pacific Technology Park [ucbvax!]hplabs!hpdstma!ken ...........................Hewlett-Packard Co.
rjn@hpfcso.FC.HP.COM (Bob Niland) (05/22/91)
re: > mbfriedman@amherst.bitnet writes... > We need some information regarding talking to an HP ScanJet through the > parallel port on the back of a Series 400 Computer running HP-UX 7.03. We > have the new parallel kernel driver, and can talk to parallel printers > fine, but we don't seem to be able to talk to the ScanJet at all. The > documentation we got in the shar does not cover talking to ScanJet's. Any > help would be appreciated I have a contributed application (Xhpscan) which I was unable to send to mbfriedman@amherst.bitnet ("host unknown"). Please send email to an address below, and include a return path that can handle a 400K shar. Regards, Hewlett-Packard Bob Niland Internet: rjn@FC.HP.COM 3404 East Harmony Road UUCP: [hplabs|hpfcse]!hpfcrjn!rjn Ft Collins CO 80525-9599