steele@thorin.cs.unc.edu (Oliver Steele) (01/12/88)
Does control-command-option-shift-"Control Panel" clear the entire parameter RAM on an SE or II? In other words, if my Mac acts flakey, and it runs a program differently when booted from a floppy after PRAM has been zapped than an identically configured Mac, recently zapped, booted from the same floppy does, does this mean that the difference is absolutely positively hardware? Specifically, uw tells me 'Can't load the RAM serial driver' (with a few letters chopped off either end of the message) and MacTerminal says 'Neither the modem port nor the printer port is available' (and then locks up and beeps forever). I'd like to know if this could be because of something in PRAM that sticks around through zaps, and I'm curious about the more general question as well. Mail responses if you have anything beyond speculation, and I'll post if there's interest. ------------------------------------------------------------------------------ Oliver Steele ...!{decvax,ihnp4}!mcnc!unc!steele UNC-CH LING Senior steele@cs.unc.edu Life is a negative-sum game.