stromme@byuvax.bitnet (11/19/88)
When I run Qued/M with Quickeys installed, keys that have been assigned different characters using the "alias" feature of Quickeys are just dead in Qued/M. If I open the Quickeys panel in Qued/M, I get a bomb, at least some ties. But even if Quickeys are disabled and I reboot, the problem persists. The only way to run Qued/M properly seems to be to remove Quickeys from the system folder. Any suggestions or comments? This is on a Mac II with 4 Megs, System 6.02, Quickeys 1.1, Qued/M 2.07. S. A. Stromme Dept. of Math. Brigham Young University (Standard disclaimer)
frank@mnetor.UUCP (Frank Kolnick) (11/20/88)
In article <276stromme@byuvax.bitnet> stromme@byuvax.bitnet writes: >When I run Qued/M with Quickeys installed, keys that have been assigned >different characters using the "alias" feature of Quickeys are just dead >in Qued/M. If I open the Quickeys panel in Qued/M, I get a bomb, at least >some ties. Yes, it happens to me too (on an SE, no that it makes a difference). I phoned Paragon (since it only happens with QUED/M on my system) about a month ago and it was news to them. I didn't get a warm feeling that they would look into it. (They did say they'd phone back, but that hasn't happened yet.) My own solution was to remap some keys to avoid the problem as best as possible. -- Frank Kolnick, consulting for, and therefore expressing opinions independent of, Computer X UUCP: {allegra, linus}!utzoo!mnetor!frank