sansom@trwrb.UUCP (Richard Sansom) (05/21/87)
In article <436@sbcs.UUCP> pmt@sbcs.UUCP (Phil Tromovitch) writes: > Did anyone manage to get the commands rx and sx to work? In the manual, >under 'sx', it says look at 'rx'. But there's no entry for 'rx' !! You can rx a file by UNDOing te (after having started up the xmodem file transfer on the other side) and typing: "rx file". I haven't tried to sx a file yet (sounds like fun ;-). Once the transfer is complete, you may resume your session by hitting the keypad "0". Now, for my troubles: I can't get the MWC 2.0 compiler to work correctly with gulam. I get errors about missing "}" characters in the pre-processor, and all kinds of other strange stuff. I _did_ set the env_type to mw, and that didn't seem to help too much (any). Does anyone out there have any ideas? Thanks. -Rich -- /////////////////////////////////////\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\ /// Richard E. Sansom TRW Electronics & Defense Sector \\\ \\\ {decvax,ucbvax,ihnp4}!trwrb!sansom Redondo Beach, CA /// \\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\/////////////////////////////////////