01659@AECLCR.BITNET (Greg Csullog) (09/10/89)
I have heard reports that Ditto II is supposed to allow printing to the SLM804 laser. I hope this is true. I use a '286/'287 PC at work and it is a real pain waiting 10 to 20 minutes for detail graphics to print out on an HP laserjet via the parallel port. The same GEM pic that took l{14 min 55 sec on the PC took only 45 seconds from a Mega 2 to the SLM804 (unfortunately, the SLM804 is not in my work area or I would use it instead of the PC/HP combo). With Ditto II, I could run GEM Draw on my ST and print it to an SLM804. That way, I could justify getting an SLM804 in my work area (with Spectre GCR I can print Mac stuff to the SLM804 as well, not to mention lots of ST code output). Question: Does Ditto II support the SLM804?????