BGB100@PSUVM.BITNET (Bruce Blanar) (11/28/89)
Below is a decription of the mod need to be made to a Commodore Amiga mouse to get the mouse to work on an Atari ST. The Amiga mouse offers a faster (slightly) tracking rate and two very comfortable buttons to use. The mod is easy to do and provides a very nice mouse. Enjoy! Commodore Amiga mouse -------> Atari ST mouse ------------------------------------------------------------------------------- This is the mod for a Commodore Amiga mouse conversion to ST mouse. No big deal about the difficulty of the conversion, but still be careful about what you do. I have included the original wire order by color so that if you do mess something up, it is here. If the wires in your mouse are different colors, I suggest writing down the color order before starting in case you switch the wrong wires. Then you can go back to START and begin again. OK...here it is. All it involves is switching two wires on the connector going to the mouse circuit board. I'll give the before and after views e of the connector wires in order from back to front (of the mouse). Before To use on an Atari ST --------- ----------------------- Black Black Blue Blue That's it! Brown -----\ /-------- Yellow Orange \/ Orange White /\ White Yellow -----/ \-------- Brown Red Red Grey Grey Like I said, the mod is not difficult. The standard disclaimer applies. I cannot take responsibility for any misfortunes that may befall you because of your using these plans for the mod. I have performed this mod and I know it works. I ripped the whole mouse apart trying to figure it out before I found out I just had to switch two wires. If you need help with the mod, ask someone you know who has the expertise to do it. Good luck! Bruce Blanar ------- =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= __ __ __ Bruce Blanar |"Everybody need a mood lifter, |__) | _ |__) Penn State University | Everybody need reverse polarity." |__).|__|.|__). BGB100@PSUVM.bitnet | -Rush voice: (814)862-8036 |