cs63bld@unccvax.uncc.edu (b. daniels) (09/07/90)
I have an ICD controller board with built in battery backed up clock.
I am using ICD's non-resident Timeset program in my auto folder,
and I also have TIMEDRV3 (the corner clock that shows disk access)
The problem is thus:
after bootup, the corner clock shows exactly the right time, but the
system clock, as seen in Flash and the control panel, is about 30~40
seconds off.
Whats going on here?
Thanks in advance,
Brian
--
----------------------------------------------------------------------
I access the net, therefore I am...
Brian Daniels (cs63bld@unccvax.uucp)
----------------------------------------------------------------------