zabot@cesare.dec.com.UUCP (01/16/87)
PAL amiga and NTSC Monitor. I've been told that a quality RGS monitor has a 'wide' bandwidth and can accept almost any type of sync. I'm not aware of SONY 11... but I can confirm the following fact: I have hooked a DEC VT241 Monitor ( NTSC ) to the composite output of Amiga (Green input). You may know that this type of monitor accept the sync either separate or with the green signal. It works even if there is something that looks like a noise ( possible due to the excessive length of the cable. Flickering : as usal ( ONLY with interlace on :-)) Most of the time the equipment you bring from USA in Europe has no problem ( unless there are syncronization problems, which may be the case for the drive. I remember an old memo of fellow taking a C64 from USA to Australia who had to replace the spinning motor). I think no problem should arise with the printer. Just in case, if you want a plug-in transformer ( 110V - 240/220 Vac) get it in the States. Radio Shack use to carry a good model ( i.e. working, low price). Hope this helps.