451061%UOTTAWA.BITNET@CORNELLC.CIT.CORNELL.EDU (Valentin Pepelea) (01/29/89)
God school takes up so much time, but inspite of the devils creation I have
*finally* upgraded to Workbench 1.3. I had a little trouble setting up rad:
so I decided that the easiest way to take advantage of the WB 1.3 features is
to simply take the WB 1.3 disk, copy my old 1.2 startup-sequence and utilities
to it, and Im ready to go. I dont need autobooting yet. But now I have a
couple of problems:
1. If I load KS 1.2 and boot WB 1.3 everything is fine. If I load KS 1.3, my
vd0: disk does not recover any more.
2. After the startup-sequence has completed, all my memory has been gobbled up
somehow. Only about 10K left! If I load KS 1.2 I have about 850K left.
Que pasa?
My set up: 68020/68881 Lucas board running at 20MHz.
1 Meg Insider.
Facc II, PopCli III, vd0:, Gomf 1.0, Conman 1.3
_________________________________________________________________________
"An operating system without Name: Valentin Pepelea
virtual memory is an operating Phone: (613) 233-1821
system without virtue." Bitnet: 451061@uottawa
Usenet: Look at the header
- Ancient Inca Proverb Planet: Earth