jmpiazza@cs.Buffalo.EDU (Joseph M. Piazza) (02/13/89)
Hi folks. It's me again. Can anybody tell me a good way to mount
a Seagate 3.5" drive (a ST-138N in particular) in a 2000?
Currently, I got the sucker about a half inch short of the front
of the Amiga's case. I have the bezel-hatch open so I can watch the drive's
activity light. And where can I get the proper mounting hardware? I only
have it anchored on one side of the drive because I don't have screws
that will fit on the other side. I've been hoping to do a better job
when I'll be opening the case to add more memory.
As an aside, is it possible to hook up the Ami's Hard Disk light
to the drive? The drive came with virtually no info whatsoever.
There is connector on the rear-left of the drive but there's three
(or is it four?) pairs of pins.
As always, please respond via email and I'll summarize and post.
Thanks,
joe piazza
---
In capitalism, man exploits man.
In communism, it's the other way around.
CS Dept. SUNY at Buffalo 14260
UUCP: ..!{ames,boulder,decvax,rutgers}!sunybcs!jmpiazza GEnie:jmpiazza
BITNET: jmpiazza@sunybcs.BITNET Internet: jmpiazza@cs.Buffalo.edu