870646c@aucs.UUCP (Barry Comer) (04/20/89)
This is a reposting of the pin connections for hooking up a Commodore monitor to an Atari ST. Well here is the pin connections for hooking up a Commodore 1084 monitor to the ST computers. First off you are doing this on your own and are taking all the risks(I guess that you need this type of header). The cable that I used is from Practical Solutions, which is a nice cable all shielded and has the ST connector already hooked up. Also included is the pinouts and their corresponding coloured wire. ST pins number Commodore 1084 6-GREEN-RGB 1 7-RED-RGB 4 9-H SYNC 2 10-BLUE-RGB 5 12-V SYNC 6 13-GROUND 3 That is all there is to it, remember to hook the shielding up to the outer shield of the 6-Pin Din plug on the monitor end. You can pick up the Din plug at Radio Shack for two bucks or so. It works for me, if you are not sure about doing this yourself GET SOMEONE ELSE TO DO IT FOR YOU! later Barry Comer 870646c@aucs.UUCP P.S. Also remember that the ST should be plugged into the ANALOG(?) RGB port.