ben@pnet01.cts.com (Ben Decker) (11/14/89)
I've installed a Spirit HDA 506 interface on my Amiga 1000. It now works properly, but I had to send it back to the company twice. Both times they took MUCH longer than they said they would to get around to looking at it. Now I've had a compatability problem with my interface and my Mini Megs. They are at MAST getting a "diode conversion" they said will take care of the problem. My Mini-Megs are one of the first they made (#138) and I have had no problems with them up until this compatability thing. Two questions: 1) Has anyone else had problems with Spirit in terms of customer support, especially in relation to the HDA-506 Hard Drive interface? And, 2) Has anyone experienced problems with memory expansions on the end of a bus pass-through not working? I'm interested in the Mini-Megs especially, but also would like to know if this is a common problem with pass-throughs / memory expansions. Thanks! -Ben ****************************************************************************** No disclaimer. I work for myself :) ****************************************************************************** UUCP: {nosc ucsd hplabs!hp-sdd}!crash!pnet01!ben ARPA: crash!pnet01!ben@nosc.mil INET: ben@pnet01.cts.com
andrews@ddmail.dec.com (11/14/89)
In article <702@crash.cts.com>, ben@pnet01.cts.com (Ben Decker) writes... >Two questions: 1) Has anyone else had problems with Spirit in terms of >customer support, especially in relation to the HDA-506 Hard Drive interface? I had to sent mine back to them because I thought that I had a problem with it. It turned out to be I didn't have a big enough power supply to power both the drive and the interface. The sent it back to me after testing it, UPS 2'nd day. Bought a new case and power supply for the drive, and everything works fine. >And, 2) Has anyone experienced problems with memory expansions on the end of a >bus pass-through not working? In my manual they have a section warning you to make sure that any memory boards that you put on the bus are first. I tried to put my starboard after the interface, and it wouldn't boot. The LED would just flash. >Thanks! > -Ben Rob