tjm@nsscb.UUCP (Timothy J. Murphy) (11/15/89)
To any and all gurus out there.... An odd problem. I purchased a 2nd floppy drive from Briwall, a Chinon 354 (?), the same brand and model that came w/ my 2000. I installed it according to the letter of the instuctions, changing the jumper on the drive itself so it would be id'd as df1:, and installing the jumper on j301 on the system board as also per the instructions. The system acts as if it only has 1 drive. The drive I got from Briwall works ok, I switched id's to check and it functions fine as df0:, but then the other drive is still not seen. The data/power cables are connected correctly, and I tried every combo of jumper configuration on the 2 drives and w/ j301. No go. I'm guessing, since the drive is ok that possibly there are other mods required on the system board that aren't outlined in the instuctions. I have a revision 6.2 system board, which I think matters, and a Fat Agnus. Any ideas? I am soooooooo frustrated.... A 1001 thank yous (not binary), Tim Murphy ...!ulysses!nsscb!tjm