d87-khd@sm.luth.se (Karl-Gunnar Hultland) (02/13/90)
Where can I get Nethack 3.0 for the Amiga? I have the source but not the patience to compile/(debug??)it. A pointer to a ftp site would be very helpful. Karl +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ | Karl 'Dixie' Hultland | email: d87-khd@sm.luth.se | | University of Lulea | : {uunet,mcvax}!sunic.se!sm.luth.se!d87-khd| | Sweden | Snailmail: Mjolkuddsv. 63-5, S-95157 Lulea Sweden | |=======================| Voice nat: 0920-15479 | | Urbi et Orbi | Voice int: +46 920 15479 | |=============================================================================| | If two people agree on EVERYTHING , one of them is OBSOLETE!! | +++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
eapu030@orion.oac.uci.edu (Jason Goldberg) (02/13/90)
In article <736@tau.sm.luth.se> Karl-Gunnar Hultland <d87-khd@sm.luth.se> writes: >Where can I get Nethack 3.0 for the Amiga? To compile the current versions (up to patch level 6) for the Amiga you need Manx 3.6 a custom Make Util and will have to do a lot of little corrections and then you will be left with Nethack 3.0pl6 which is buggy anyway. The finnal version of NetHack 3.0 is supposed to be patch level 7 and it is allready overdue. Dupposedly the only thing holding it back is E-Mail probs. Anyway the Amiga development team allready has all the revised Makesfiles and have cleaned up the code considerably so that it will compile cleanly with a Stock Lattice 5.04 or Manx 5.0, under patch level 7. So my advice to you is just wait for pl7. -Jason-
gregg@cbnewsc.ATT.COM (gregg.g.wonderly) (02/16/90)
From article <25D7A6A5.5780@orion.oac.uci.edu>, by eapu030@orion.oac.uci.edu (Jason Goldberg): > Anyway the Amiga development team allready has all the revised > Makesfiles and have cleaned up the code considerably so that it will compile > cleanly with a Stock Lattice 5.04 or Manx 5.0, under patch level 7. So my > advice to you is just wait for pl7. This is not quite true. The Manx 5.0 support will not be in pl7. Lattice support is there. The need for the cpp and make will be gone for Manx 3.06, the Manx make (and others) will work after a few changes to the makefile. -- ----- gregg.g.wonderly@att.com (AT&T bell laboratories)