mmartin@nmsu.edu (Marilyn Martin ) (05/09/90)
I just got RAM put on my 2091. Used Mergemem to assign addresses. Memory shows up on Workbench and on status line in Sculpt 4D. Here's the problem: when Sculpt tries to use RAM above standard 3M, it gurus! Has anybody out there installed RAM on their 2091? I have a 2500/30; is the coprocessor causing a problem? Also: when I used RAMtest it tells me the RAM is there but gives me BAD BIT reports on all addresses. Help! Signed, Megafrustration I can't believe I maxed my card for this!!!! Marilyn Martin New Mexico State University Computer Center Las Cruces NM 88003