dean@coplex.UUCP (Dean Brooks) (06/06/90)
A couple of weeks ago, I ran across a message that mentioned a bug
in GVP's GVPprepHD program that caused the Max Transfer Rate to be set much
too low, causing very bad performance on the ST296N (Seagate 80 MB SCSI) on
my Amiga 2000.
Could the author report/mail more detailed instructions on how to change
the Rigid Disk Block of the hard drive to reflect a new transfer rate?
Is this indeed a correct solution to the bad performance I am
getting out of this drive/controller combination? I know the ST296N is
a slow drive, but it is not THAT slow. Any help would be appreciated.
Thanks in advance...
--
dean@coplex.UUCP Dean A. Brooks
Copper Electronics, Inc.
Louisville, Ky
UUCP: !uunet!coplex!dean