davemad@pnet01.cts.com (Dave Madsen) (07/17/90)
Being a fairly new user of both Amiga software and a HP Deskjet, I seem to be having a few problems with the printing of some programs. It seems that most of the GoldDisk software (ProPage, PageSetterII, ProDraw, etc.) improperly handles the hardware margins that the DeskJet has. For instance, if I were to draw a box at a point one inch from the top and one inch from the left (using the ruler guides in any of the previously mentioned programs), it would print out approximately 1.5 inch from the top and 1.25 inch from the left. If I were to try and print that same page again, it would be offset even more to the right and down and would continue to print further to the right and down in any additional pages I had. Now, if I reset the printer between EVERY page of EVERY document, I can keep the offset at 1.5 from the top and 1.25 from the right. If I THEN move EVERYTHING on EVERY page up 0.5 inch and to the right 0.25 inch, I can keep the page at the position it is supposed to be at. However, I think this is a REAL BIG pain in the butt that I shouldn't have to go through in the first place. After reading a message on the net about a possible fix for the use of a DeskJet with PageSetterII, and since mail to the original poster bounces, I thought I would put out a plea for help so I might get my hands on such a fix. Any comments/tips/suggestions would be appreciated, thanks! -----------------------------------------------------+------------------------+ UUCP: {hplabs!hp-sdd ucsd nosc}!crash!pnet01!davemad + Dave R. Madsen + ARPA: crash!pnet01!davemad@nosc.mil + Computer Science Major + INET: davemad@pnet01.cts.com + Iowa State University + -----------------------------------------------------+------------------------+
aaronf@hpfcbig.SDE.HP.COM (Aaron Friesen) (07/18/90)
If I remember correctly, the DeskJet has some of the same limitations as many laser printers: it can't print clear to the edge of the page. If you read through the documentation for the DeskJet (I haven't, but this information is included in the LaserJet documentation, if I remember correctly) you should find a reference to the 0.5 and 0.25 inch offsets. Take this with a grain of salt, as it is all from memory. The documentation is not sitting in front of me. Aaron