wampler@unmvax.UUCP (03/23/87)
I have an AT clone that runs at 8 MHz. The current standard seems
to be 12 MHz. As cheap as the new clones are, I already have
an EGA, serial ports, disk controller, hard drive, etc. I would
just like to upgrade the motherboard. (In fact, I suspect this may
be a common problem.) Does anyone know where to acquire an
AT motherboard only. I would just like to replace the one I have.
I suspect that such a board should be about $500-$700.
I will post a summary to the net, so please reply directly.
--
Dr. Bruce E. Wampler
University of New Mexico
Department of Computer Science
Albuquerque, NM 87131
..{ucbvax | seismo!gatech | ihnp4!lanl}!unmvax!wampler