rbourass@udenva.cair.du.edu (Mr. Photography) (04/09/88)
Just replaced my DTK XT motherboard with a DTK Baby 286 motherboard. Everything running well with one exeption. DOS is not picking up the time from the built in clock. As with most 286 boards, there is a built in clock and a setup utility. The board is holding and maintaining the correct time and date, but DOS only reads the date. Typing C:\> time <RET> results in a value in hours and minutes that reflects how long it has been since the last power-up or reboot. The "date" function works fine. SYSTEM: DTK 6/10 Mhz Baby 286 1024 K Multi I/O Card (Floppy cont, Serial, Parallel, Game, disabled clock/cal) (2) 360k Drives CGA w/parallel Plus HardCard 20 with 286 rom upgrade Any help will be greatly appreciated! Please respond via E-mail to: rbourass@udenva Thanks again! Rich a