simon@ms.uky.edu (Simon Gales) (01/22/89)
I have installed a monochrome card in my AT, which already had an
EGA card/monitor. Everything works fine - I switch to the mono monitor
by doing 'mode mono', and to the EGA one with 'mode co80'.
But when on the mono monitor, everything is underlined! I know that there
is an attribute bit being set that there shouldn't be, any known solutions?
--
/--------------------------------------------------------------------------\
Simon Gales@University of Ky UUCP: {rutgers, uunet}!ukma!simon
(- Insert Virus Code Here -) Arpa: simon@ms.uky.edu
MaBell: (606) 263-2285/257-3597 BitNet: simon@UKMA.BITNET