mike@cs.keele.ac.uk (Michael A. Green) (03/09/89)
I have just installed a 3.5" floppy drive as drive 1 on my AT clone (Beltron) I also have a 1.2MB floppy in drive 0, a 20MB and a 40 MB hard disk. The Problem: It works ok both as 720KB and 1.44MB for a while, then I get Divide Overflow and I have to reboot the computer before I can use the drive. I also use my system with Uport System V/AT. The drive works with that for a while, but soon I get "Channel number out of range" on which ever drive is not mounted. This is basically the same problem I think The controller card is a WD1003-WA2, with no previous problems. If anyone has any ideas could they please e-mail me at one of the addresses in my signature NOT by the return path of this posting ... I get enough hassle here about the cost of UUCP traffic as it is :-( and the Internet gateway through nss.cs.ucl.ac.uk is free :-)). Thanks for any help. -- |Michael A. Green. |JANET: mike@uk.ac.keele.cs | |Department of Computer Science |BITNET: mike%cs.kl.ac.uk@ukacrl | |University of Keele, Keele, |ARPANET: mike%cs.kl.ac.uk@nss.cs.ucl.ac.uk | |Staffordshire. ST5 5BG. U.K. |VOICE: +44 782 621111 ex. 3357/3347 |