jaglak@ogccse.ogc.edu (Kevin Jagla) (03/16/89)
I recently purchased the upgrade package for Micografx Draw Plus To install this I needed to upgrade my DOS from 2.11 to 3.0 or higher. So I purchased a copy of AT&T's 3.3 DOS. I followed the instructions and installed the 3.3 without completely reformatting. The result was my 20Mb ST-225 drive would go off on what appeared to be a seek and never return. So I took the system down, and re-installed the DOS 3.3 complete with a reformat. Once again my drive was unable to operate, (red light on no further results). This re-format was the idea of AT&T when I made a service call. I reformatted to 2.11 again, and now I am up and running, lots of room! But I still can't install Draw Plus. 1. Has this type of problem been experienced by anyone else? If so what do I need to do that I have not done??