mike@ut-emx.UUCP (Mike O'Donnell) (05/04/89)
I have been trying to build GNUPLOT for a PC with a Hercules graphics board and have had no luck. The sparse documentation says to build with Microsoft C , run 'make make.msc'. I am running version 4.0 and there appears to be no make command. When I create a .bat file and compile all of the modules by hand, the linker says that there is a 'fix up error' in module pcgraph. I think the problem is at the line 'jmp _interrupt'. I changed the order of the modules and the error goes away. However the Hercules output is not working. THe screen is really whacko. Has anybody gotten this program to work on the PC? If so, any hints, fixees, help, etc. will be greatly appreciated. Thanks, Mike O'Donnell
wew@naucse.UUCP (Bill Wilson) (05/06/89)
From article <12759@ut-emx.UUCP>, by mike@ut-emx.UUCP (Mike O'Donnell): > I have been trying to build GNUPLOT for a PC with a Hercules > graphics board and have had no luck. The sparse documentation > I was able to rewrite the code so that it would compile very well with Turbo C. The implementation supports Hercules, EGA/VGA, CGA and a few other graphics protocols. If there is enough interest I will put the source on the net. -- Bill Wilson (Bitnet: ucc2wew@nauvm) Northern AZ Univ Flagstaff, AZ 86011 {Let sleeping dragons lie......}
mike@raven.TELCOM.TEK.COM (Mike Ewan) (05/10/89)
In article <1416@naucse.UUCP> wew@naucse.UUCP (Bill Wilson) writes: >I was able to rewrite the code so that it would compile very well >with Turbo C. The implementation supports Hercules, EGA/VGA, CGA >and a few other graphics protocols. If there is enough interest I will >put the source on the net. > Yes, please post it. -- Michael Ewan (503)627-6468 ucbvax...\ Tektronix Inc. decvax....\ mike@raven.TELCOM.TEK.COM uw-beaver.... >!tektronix!naps!raven!mike Fig Newton: The force required to accelerate a fig 39.37 inches/sec.