lurifax@freja.diku.dk (Michael Brian Moustgaard) (05/24/89)
>In article <8275@pyr.gatech.EDU> ccastgw@pyr.gatech.edu (GREG WILLIAMS) writes: >I have two hard disks on my PC/XT clone. One is an ST-238R and the other >is an ST-251N (SCSI). Currently my PC boots off the 238. I would like to >fix it so that I boot off the 251. I looked at the addresses for the 2 >drives using debug. The 238 is at C800 and the 251 is at CA00. I am >assuming that whichever drive is at C800 is the one booted from. Is >this true? If so, how do I switch the 2 addresses to boot from the 251? > Another thing to do, if you have Norton's NU, is to go into "Explore disk", "Choose item" and "Absolute sector", then you press RETURN four times, and you will get the "PARTITION TABLE" on screen, here you can see, whether this disk is bootable or not. Make the one you wish to boot from bootable, and the other one non-bootable. But be CAREFUL when doing this, do NOT change anything else. Hope this helps. Michael B. Moustgaard Student at DIKU-DK Denmark Freelance-programmer. -------------------------------------------------------------------- Bitnet-address : lurifax@diku.dk.bitnet