bose@iuvax.cs.indiana.edu (08/01/89)
I have a sony multiscan 1302. It flickers in the 800x600 vga mode. I understand this is due to the fast phosphor rate. 1. Does sony make a monitor that will not flicker in the higher res. modes? 2. Are there any large (16inch or greater) monochrome monitors that will handle the 800x600 super vga mode? Thanks, in advance.
bruce@tolerant.UUCP (Bruce Hochuli) (08/01/89)
In article <36300052@iuvax> bose@iuvax.cs.indiana.edu writes: > >1. Does sony make a monitor that will not flicker in the higher res. modes? Unknown >2. Are there any large (16inch or greater) monochrome monitors that will > handle the 800x600 super vga mode? > The NEC multisynch XL is a 19" monitor that will. I had set up a system like this for a serious AutoCad User (a mechanical engineer) and there was no flicker at all. Yes I did run it at 800X600 and used the drivers supplied by the adaptor vendor (Vega in this case). These cost about $2000. There is a Mitsubishi 16" monitor and a Nanao 16" monitor that both claim to handle super VGA. I have used the Nanao but not as super VGA. I have no experience with the Mitsubishi but they claim higher reslotion than Nanao. These cost about $1000. Someone out there, I think it is Mitsubishi but I am not sure, has a 20" high (claimed) resolution monitor. I have never seen this one is action. >Thanks, in advance.