Greg.Miller@hogbbs.FidoNet.Org (Greg Miller) (02/26/90)
I just got the new TANGO PCB demo disks from ACCEL. I thought the old
demo version (c. 1987) looked just fine, except that I wanted to get a
camera-ready hard copy from my Epson 9-pin printer. (A bit crude, but
acceptable for small quantities at 2X or even 4X.) New version
won't run on my Multispeed, because of different requirements for RAM,
display, and hard drive. For my needs, new version is useless.
(Seems as if Accel ALMOST had a good thing, and then made it TOO good.
This is "progress!") Sooooo.....
Does anyone know of any way to get camera-ready copy from a 9-pin
printer, using the 1987 version? (This feature was to be added to the
newer version, which I can't run.) Maybe a 3rd-party driver, etc.?
Also, does anyone want to sell the complete older version of TANGO-PCB
and TANGO-ROUTE (disks, manuals, hardkey, etc. etc.)? <<< GREG >>>
--- QuickBBS v2.61 [REGISTERED]
* Origin: The Heart of Gold - hogbbs.fidonet.org - (1:129/87.0)
--
Greg Miller via The Heart of Gold UUCP<>Fidonet Gateway, 1:129/87
UUCP: ...!{lll-winken,psuvax1}!psuhcx!hogbbs!Greg.Miller
Internet: Greg.Miller@hogbbs.FidoNet.Org