dchun@aludra.usc.edu (Dale Chun) (03/26/90)
After recieving my NEC 3D monitor in the mail, I noticed that the preset brightness was set up too high and the horizontal picture preset was set too far to the right. My question is, is the factory preset controls for these two adjustments easy to get access to or do I have to visit my "trusty" NEC technical repair center, wait 8 months while some guy just turns some factory screws to fine tune an otherwise perfectly functioning monitor? Thanks for any insight. ...dale
dlow@hpspcoi.HP.COM (Danny Low) (03/27/90)
>After recieving my NEC 3D monitor in the mail, I noticed that the >preset brightness was set up too high and the horizontal picture >preset was set too far to the right. My question is, is the factory >preset controls for these two adjustments easy to get access to or do >I have to visit my "trusty" NEC technical repair center, wait 8 months >while some guy just turns some factory screws to fine tune an >otherwise perfectly functioning monitor? Thanks for any insight. > ...dale Read the manual. It tells how to adjust both problems. There are knobs on the monitor to do this. Danny Low "Question Authority and the Authorities will question You" Valley of Hearts Delight, Silicon Valley HP SPCD dlow%hpspcoi@hplabs.hp.com ...!hplabs!hpspcoi!dlow