jka@mris.larc.nasa.gov (J. Keith Alston) (06/10/91)
Hello,
My system consists of a 386/25 with a WD1006V-SR2 RLL disk controller
and a 65 Mbyte mitsubishi MR-535 drive. I've just purchased another
65 Mbyte drive, miniscribe 3675. I disconnected the mitsubishi drive
and connected up the miniscribe, and was able to format it and bring
it up ok. What I want to do is puT The mitsubishi back as the C: (primary)
drive and add the miniscribe as the D: drive since my controller can
handle 2 HD's. What I need to know is are there any jumper settings
that I should know about on either drive, or the contoller? also
how should the setup be terminated or do I not need to worry about
this?
Any help would be greatly appreciated,
Keith Alston
jka@snow.larc.nasa.goV