cliff@fubar.UUCP (Cliff Elam) (09/30/87)
I just finished putting togeather my 0.0K combo board. I followed
the list put out by Craig Votava (ihnp4!looney!cmv) with the following
amendmants: I used a 74LS74 instead of a 74ALS74 and I made the 33 ohm
resistor netwoks out of 33 ohm resistors like this:
pin: 1 2 3 4 5 ....
------------- (there are more pins but that would be boring)
| | | | | (each individual resistor is 33 ohms)
| < < < <
| > > > >
| < < < <
| > > > >
When I put the board in (after disconnecting my HD - just call me
freshly backed up and paranoid) I booted off floppy and the 7300
recognized the Combo board in slot one, but no expansion memory.
Hmm, thinks I, bad news. I double checked the jumpers (W1 && W2),
the chip orientation, the chip temperatures (feel normal to me),
everything.
Do I need some s/w drivers that I don't have? Thoughts? Anybody
with a scope-brain interconnect have any ideas?
-cliff elam
(919) 942-6024 (v)
967-4249 (d)
--
{ihnp4!mcnc}!ethos!fubar!cliff
Increase our bandwidth: shrink headers, use abbrev's, BAN CUTE SHIT!