[comp.sys.att] 3b2/300 - 310 upgrade

randy@chinet.UUCP (Randy Suess) (05/04/88)

the 4 roms out of the 300 and put it in the 310, but all went well.
My question is, is there anything I should do software-wise to take
advantage of the new processor chip set?  Should I re-install
the core software, and/or recompile any source?  My understanding was
that the old processor required tons of no-ops in the executables
to make up for some bugs, but the newer 32100 does not.
Any info would be appreciated.

-randy

-- 
that's the biz, sweetheart.....
Randy Suess
..!{att-ih | ihnp4}!chinet!randy

randy@chinet.UUCP (Randy Suess) (05/04/88)

In article <5089@chinet.UUCP> randy@chinet.UUCP (Randy Suess) writes:
>the 4 roms out of the 300 and put it in the 310, but all went well.

	Jeeze.  Don't know how I managed to mangle that!
	Here it is again, all of it, I hope....
	(It's small, take a bunch)
-------------

	I have a very old 3b2/300 running SysVr3.1.  I just obtained
a 3b2/310 motherboard, and replaced the 300's with it.  I had to take
the 4 roms out of the 300 and put it in the 310, but all went well.
My question is, is there anything I should do software-wise to take
advantage of the new processor chip set?  Should I re-install
the core software, and/or recompile any source?  My understanding was
that the old processor required tons of no-ops in the executables
to make up for some bugs, but the newer 32100 does not.
Any info would be appreciated.

-- 
that's the biz, sweetheart.....
Randy Suess
..!{att-ih | ihnp4}!chinet!randy