jdevries@zodiac.ads.com (Jeff De Vries) (07/26/88)
I have a couple of questions I'm hoping someone might know the answer to: 1) If you put a printer on the serial port, does the 7300 use hardware or software flow control. I am running 3.51. If it uses hardware flow control, which line is it expecting the info on? (DSR, DCD, CTS ???) 2) I brought up GNU Emacs 18.51 on the 7300 using TERMCAP, but I can't seem to get it to load using TERMINFO. I have TERMINFO installed on the 7300. Loader complains about not finding several of the routines in curses, i.e. tparm etc. I am using -lcurses, as per the 7300 manual on TERMINFO. If I try to specify both -lcurses -ltermcap I get errors about PC being multiply defined with different sizes. What am I not doing right? Thanks! Jeff De Vries jdevries@ads.com (ARPA) /* usual disclaimer */