wouk@romeo.cs.duke.edu (Arthur Wouk) (03/15/89)
i have the following problem: i have an att3b1=7300, a desktalk II modem and c-kermit 4E(072) source. i have modified ckudia.c so that it recognizes the desktalk II and dials through it properly. the modem then does its work and and dials the remote number, connects to it, gets a dial tone and sets up what it calls the dsr signal on pin 6 of the rs232 communications port. at this point the system hangs with locked keyboard. i can only assume that there is some place where i have to tell it to look for the dsr signal on pin 6, since when i use the onboard modem it has no problems accepting the equivalent signal, giving a prompt, and accepting a subsequent connect command. what i need to know is: where is the carrier signal detect code located? is in in ckudia.c, and if so, where? if not, where else should i look?