[comp.sys.att] 3B2 600 UUCP VIA DATAKIT

jccc@killer.Dallas.TX.US (Juan Castillo) (05/03/89)

We need info on how to get UUCP to work through DATA-KIT. 

gentry@kcdev.UUCP (Art Gentry) (05/04/89)

In article <7996@killer.Dallas.TX.US>, jccc@killer.Dallas.TX.US (Juan Castillo) writes:
> We need info on how to get UUCP to work through DATA-KIT. 

Not much to go on, but hopefully this is what you need:

In DataKit[tm] get into the cimmand mode {datakitcm}
  Set the following options on the port you want to do uucp on:
     set dkfc none  <---turns off flow control
     set fc none    <---  "    "    "    "
     set attn ~     <---sets attention character to tilda

Make sure you do the above on the endpoints for both computers.
Hope this helps, you didn't give us much info on your end to go on.

Art
opinions my own and so on....